If you want to buy a replacement screen, screwdrivers and other parts, you can order from us
here:
Motorola U9 LCD screen
Tools required for disassembly: Torx 3 screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Open the flip then slide your plastic tool around the edge of the
plastic lens to remove it.
- Your phone should now look like below. Remove the four screws you
can see. Note that the two at the bottom are black and the two at the
top are silver and these need to go back in the right place as they're
slightly different lengths.
- Run your plastic tool around the join of the top cover in order to
release it.
- Your phone should now look like below.
- Lever the metal frame off at the two points shown below. Do the same
on the other side.
- You should now have the metal frame removed. Three ribbons now need
disconnecting. The two small ribbons have a foam sticker on which needs
to be removed. Then note the black latches. Flick the black latches up
and then side each ribbon out. You can then lift the green circuit board
away from the phone. You'll need to waggle it around until it slides
over the small screen.
- Your phone should now look like below. Lever the screen out at the
points circled below.
-
You should now have the screen removed.
-
Slide your plastic tool behind the small screen to separate it from the
large screen. You'll need some double sided tape to stick this back
down.
-
You should now have both screens removed. Reverse the whole
procedure for reassembly. If you've found this disassembly guide useful, please support us and order the tools and parts you need from our site. We ship worldwide!
If you have any questions about how to take apart and repair your broken Motorola U9, email
rob.lee@formymobile.co.uk or contact us on Facebook for further help with
Motorola U9 disassembly.
If you want to buy a replacement screen, screwdrivers and other parts, you can order from us
here:
Motorola U9 LCD screen
|
