If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=toccolcd
Tools required: Phillips size 0 screwdriver
- Remove your back cover, battery, sim and memory card. Now remove the
four screws you can see.
- Run something like a credit card or guitar plectrum around the join
of the battery compartment to release it.
- Your phone should now look like below. The four circled connectors
need disconnecting. The connector bottom right, with the thin wire
leading from it, needs to be levered off. It will come off without much
force. Each of the other three connectors attach like a plug and socket.
Simply lift them up to unplug them. You should also be able to see
another screw holding the circuit board in place. Remove this.
- You should now be able to remove the circuit board. There are
various wires and ribbons in the way so you need to carefully move the
circuit board around until it is loose and can be moved freely. You'll
notice that a ribbon connector (circled), which attaches to the other
side of the circuit board, has become unplugged. Remember to reconnect
this when you put the phone back together. The camera, circled in red,
is lightly stuck down and needs to be released. Just lift it up, noting
that it is still attached by a ribbon, and it should come loose.
- Now lift the grey part from right to left to remove it. A few clips
around the edge of the phone hold it in place.
- Your phone should now look like below.
- Now use something like a credit card or guitar plectrum to lever the
LCD from the point shown. Double side tape holds the screen in place
lightly.
-
You should now have the LCD removed. Reverse the whole procedure for reassembly.
If you have any questions about Samsung Tocco F480 disassembly, email
rob.lee@formymobile.co.uk. The official service manual for this phone may also help you with further
Samsung Tocco F480 disassembly. Click here for details
|
|
ABOUT
