If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=p1lcd
Tools required: Torx 6 screwdriver, Phillips size 0 screwdriver
- First remove the battery cover, battery, memory card and stylus.
Remove the three screws you see
- Run your fingernail around the join of the back cover and then pry
the back cover off
- Your phone will now look like below. Now remove the two screws you
can see at the top of the phone
- Now run your fingernail along the join of the front cover and you'll
hear the clips, which hold the cover on, click. The front cover is on
quite tight so use some force to pry the cover off
- With the front cover removed your phone will
look like the picture below
- Remove the keypad and lift the part underneath from right to left,
as shown below to reveal two more screws. Remove these screws
- Remove the metal plate that the screws were holding in place and you
now have access to the ribbon which attaches the screen to the circuit
board
-
Detach the ribbon to remove the LCD screen. The ribbon attaches like a
plug and socket. Simply lift the ribbon up away from the circuit board
to detach it
-
You have now removed the LCD screen. Reverse the whole procedure for
reassembly
If you have any questions about Sony Ericsson P1i disassembly, email
rob.lee@formymobile.co.uk. The official service manual for this phone may also help you with further Sony Ericsson P1i disassembly. Click here for details
|
|
ABOUT
