If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=orbitlcd
Tools required: Torx 6 screwdriver.
- First remove the battery cover, battery, memory card and stylus.
Remove the four screws you see.
- Run your fingernail around the join of the back cover and then pry
the back cover off.
- Your phone will now look like below. Now remove the four screws you
can see (two at the top of the phone and two at the bottom).
- The front part of the phone can now be removed from the middle
chassis. Carefully pull the two parts apart.
- With the two parts separated your phone will
look like the picture below.
- You can now remove the front cover. It will be held to the screen
with double sided tape so the front cover needs to be carefully peeled
away.
- The front cover has now been removed and you have access to the LCD
screen.
-
The screen is held in place by metal clips. Pry the screen away from the
rest of the phone, lifting it from right to left, as shown below.
-
The LCD screen will now only be attached by the ribbon. There is a black
hinge where the ribbon attaches. Flip this up (from right to left) and
then simply pull the ribbon out. Pay attention to how the ribbon
attaches.
- You have now removed the LCD screen. Reverse the whole procedure for
reassembly.
If you have any questions about O2 XDA Orbit disassembly, email
rob.lee@formymobile.co.uk or contact us on Facebook for further help with O2 XDA Orbit disassembly.
If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=orbitlcd
|
