If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=jetlcd
Tools required: Phillips screwdriver, plastic tool such as a credit card.
- Remove your back cover, battery, sim and memory card. Six screws
need to be removed, circled below.
- With a little force you can pry the battery compartment off. The
volume and camera buttons will also come loose. Your phone will then
look like below.
- The micro switches for the lock button (circled below, left) and
volume button (circled below, right) are stuck to the side of the phone
with double sided tape and can be carefully peeled away from the side of
the phone leaving them still attached to the circuit board, as shown
below.
- Pull the circuit board towards you and you'll see a ribbon connector
(circled below). This attach like a plug and socket. Just lever it up,
away from the phone, to unplug. The circuit board will now be free.
- Your phone should now look like below. The three ribbons circled in
red need to be detached. Again, each attaches like a plug and socket.
Just lever each one up to unplug. The part circled in green is attached
to the circuit board at one end and attached to the phone housing at the
other end with double sided tape. You need to carefully lever it up to
release.
- You can then lift the circuit board away from the phone. Note that
another ribbon connector (circled in green, below) will disconnect as
you remove the circuit board. Now remove the screw circled in blue.
Remove the antenna by prying along the dotted line shown below. As you
remove the antenna, another connector, circled in red below, needs to be
levered up. Again this has a plug and socket type connector.
- With the antenna removed your phone will look like below.
-
Next, carefully peel the identification sticker off, as shown below.
Then push your screwdriver into the circled points. This will release
the keypad on the other side.
-
With the keypad removed your phone should look like below. The connector
circled below connects in a slightly different way to previous stages.
Just flick the black latch up, opposite to the side the ribbon enters
its socket. The ribbon will now be loose. Now pull the front cover in
the direction shown by the arrows to manipulate it so that the front
cover separates from the black metal plate, indicated by the dotted
line. Some force is required.
-
Your phone should now look like below. The ribbon circled is the one you
released in the last stage.
- Now slide something like a credit card all the way under the LCD
screen to release it.
-
You should now have the LCD screen removed. Reverse the whole procedure
for reassembly.
If you have any questions about Samsung Jet S8000 disassembly, email
rob.lee@formymobile.co.uk. The official service manual for this phone may also help you with further
Samsung Jet S8000 disassembly. Click here for details
|
|
ABOUT
