If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=h1lcd
Tools required: Phillips screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Remove your back cover, battery, sim and memory card. Five screws
need to be removed, circled below.
- Next remove the screws on either side of the phone.
- Run something like a credit card around the join of the battery
compartment to lever it away from the rest of the phone.
- With the battery compartment removed your phone should look like
below. Three ribbon connectors (circled in white)
need to be disconnected. Each attaches like a plug and socket. Just lever
each one up to unplug. Next, remove the five circled screws. The two at
the bottom are black and a different length from the other three.
Remember this when you put the phone back together.
- Lift the circuit board up and a ribbon cable, circled in white will
disconnect. Another ribbon cable needs disconnecting. Again, this
attaches like a plug and socket. Lever it away from the circuit board to
unplug.
- Now pry away the front cover and your phone will look like below.
The sim card reader and speaker will also come away. The ringer,
indicated by the arrow, is attached to the circuit board by wires but
stuck in place with double sided tape. Lever it up with your
screwdriver, making sure not to break to wires connecting it to the
circuit board.
- Lift the circuit board away and the camera will also come loose, as
shown below. Two ribbons, circled in red, need disconnecting. This type
of connector is called a zif connector. The black part is a latch which
opens and closes on a hinge. Flick the latch up, towards the ribbon, and
you can then pull each ribbon out of its socket.
-
Below you can see the two ribbons once disconnected.
-
Turn the part over and your phone should look like below. Lift the green
sticky tape up, indicated by the arrow, and then pull the touch screen
away from the phone.
-
With the touch screen removed your phone should look like below.
- Now carefully run your plastic tool all the way around the very edge
of the screen and lever it out.
-
You should now have the LCD screen removed. Reverse the whole procedure
for reassembly.
If you have any questions about Vodafone 360 Samsung H1 (GT-i8320) disassembly, email
rob.lee@formymobile.co.uk. Or contact us on Facebook for further help with
Vodafone 360 Samsung H1 (GT-i8320) disassembly.
If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=h1lcd
|
