If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=e1000lcd
Tools required: Torx 6 screwdriver, plastic
tool such as a guitar plectrum or credit card.
- Remove your back cover, battery, sim and memory card. Remove the six
screws you have access to.
- The front cover will now be loose and can be removed.
- The battery compartment will also be loose and the phone can be
separated again, as shown below.
- Release a clip on the right side of the plastic part shown below
then lift to the left to reveal a ribbon connector (circled). This
attaches like a plug and socket.
Simply lift each connector up, away from the circuit board, to unplug
it.
- Your phone should now look like below. Another ribbon connector
(circled) needs to be disconnected. Again, this is a plug/socket type
connection.
- Turn the phone over and remove the two circled screws.
- The metal frame which holds the LCD screen will now be loose and can
be separated from the circuit board.
-
Slide your plastic tool underneath the LCD screen to release it from the
frame.
-
You should now have the LCD screen removed, as shown below. Reverse the
whole procedure for reassembly.
If you have any questions about Motorola E1000 disassembly, email
rob.lee@formymobile.co.uk. The official service manual for this phone may also help you with further
Motorola E1000 disassembly. Click here for details
|
|
ABOUT
