If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=diamond2lcd
Tools required: Torx 5 screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Remove your back cover, battery, sim, stylus and memory card. Four screws
need to be removed, circled below.
- Lift the black part, shown below, away from the phone.
- Run something like a credit card around the join of the battery compartment, in order to release it.
- With the battery compartment removed, your phone should look like below. Four connectors, circled below, needs to be disconnected. Starting with the smallest one, top right, just flick the
black latch up and pull the ribbon out at the other end. The other three connectors have a plug and socket type connection. Just
lever each one up to unplug.
- Below is a close up showing all the disconnected ribbons/wires. The camera module will also now be loose. You can now lift the circuit board away from the phone's housing. It's held in place lightly with clips all the way around its edge which you can pry away to release the circuit board.
- With the circuit board removed, your phone should look like below. Now peel away the two circled pieces of sticky tape. The screen will now be free and can be lifted out.
-
You should now have the LCD screen removed. Reverse
the whole procedure for reassembly.
If you have any questions about HTC Touch Diamond 2 disassembly, email
rob.lee@formymobile.co.uk or contact us on Facebook for further help with
HTC Touch Diamond 2 disassembly.
|
|
