If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=c903lcd
Tools required: Torx 6 screwdriver, Phillips screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Remove your back cover, battery, sim and memory card. Remove the
five screws you can see.
- Run something like a credit card around the join of the battery
compartment to release it from the rest of the phone.
- Lift the circuit board up from the left side. Two ribbon connectors (circled)
need to be disconnected. They attach like a plug and socket. Just lever
each one away from the circuit board to unplug.
- With the circuit board removed your phone should look like below.
Remove the four circled screws. You now need to move the slide part up
and down until it releases.
- Your phone should now look like below. Two more screws need to be
removed (circled). They're covered by stickers that you can push off
with your screwdriver.
- Now run your credit card around the join of the front cover to
release it.
- You should now have the front cover removed.
-
The keypad part needs to be lifted up to access the ribbon connector
from the LCD screen. It's stuck down with double sided tape so try and
pry it away with your fingernails. Another ribbon connector (circled)
need to be disconnected. Again, this attaches like a plug and socket. Just lever
it away from the circuit board to unplug.
-
You can now lift the LCD screen away. Reverse the whole procedure for
reassembly.
If you have any questions about Sony Ericsson C903 disassembly, email
rob.lee@formymobile.co.uk or contact us on Facebook for further help with
Sony Ericsson C903 disassembly.
|
|
ABOUT
