Your basket  Your basket
0 product(s) - Sub total £0.00
Checkout

Repair guides »

Samsung B3210 Genio QWERTY disassembly, screen replacement and repair



If you want to buy a replacement screen, screwdrivers and other parts, you can order from us here - Samsung B3210 Genio QWERTY LCD screen

Tools required for disassembly: Phillips screwdriver, plastic tool such as a guitar plectrum or credit card.

Remove your back cover, battery, sim and memory card. Six screws need to be removed, circled below. Samsung B3210 Genio QWERTY disassembly stage 1 Run something like a credit card around the join of the battery compartment to release it from the rest of the phone. Samsung B3210 Genio QWERTY disassembly stage 2 With the battery compartment removed your phone should look like below. Two ribbon connectors, circled below in white, need to be disconnected. Each attaches like a plug and socket. Just lever each one up to unplug. Next, remove the screw you can see, circled in red. Samsung B3210 Genio QWERTY disassembly stage 3 You can now remove the yellow sim reader assembly, as shown below. Two clips, circled below, hold the circuit board in place. Pry the front cover where the clips are in order to release the circuit board. Samsung B3210 Genio QWERTY disassembly stage 4 With the circuit board and front cover separated your phone should look like below. Samsung B3210 Genio QWERTY disassembly stage 5 Turn the circuit board over and you'll see the speaker, circled below in red. This is held in place with some double sided tape. Use your screwdriver to lever it away from the circuit board. Be careful not to damage the wires connecting the speaker to the circuit board. Samsung B3210 Genio QWERTY disassembly stage 6 Turn the circuit board over again. You can see the speaker sticking out at the top of the phone, still connected to the circuit board by two wires. A ribbon connector, circled below in red, needs to be disconnected. Again, it attaches like a plug and socket. Just lever it up to unplug. Samsung B3210 Genio QWERTY disassembly stage 7 You should now be able to lift the circuit board away, as shown below. To release the LCD screen, push your screwdriver into the gap circled below. This will raise one corner of the LCD screen allowing you to slide something thin and flat like a credit card under the screen and release the double sided tape holding it in place. Samsung B3210 Genio QWERTY disassembly stage 8 You should now have the LCD screen removed, as shown below. Reverse the whole procedure for reassembly. If you've found this disassembly guide useful, please support formymobile.co.uk and order the tools and parts you need from our site. We ship worldwide! Samsung B3210 Genio QWERTY disassembly stage 9
If you have any questions about how to take apart and repair your broken Samsung B3210 Genio QWERTY, email rob.lee@formymobile.co.uk. Or post a comment below for further help with Samsung B3210 Genio QWERTY disassembly.

If you want to buy a replacement screen, screwdrivers and other parts, you can order from us here - Samsung B3210 Genio QWERTY LCD screen