If you require a new screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=5800lcd
Tools required: Torx 5 screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Remove your back cover, battery, sim, stylus and memory card. Remove
the four
screws you can see then pull the coloured outer band at various points
in the direction shown by the arrows below. This will release the clips
holding the band in place.
- Your phone should now look like below. The key lock sliding button
will also come away with the coloured band.
- Release the front cover in the same way you released the coloured
band, pulling at various points around its outer edge. Start near the
bottom as there is a ribbon cable at the top of the phone which can be
damaged if too much force is applied to it.
- Lift the cover up and back so that it looks like the photo below.
Note that it is still attached by a ribbon cable at the top of the phone
so don't try and separate it from the rest of the phone just yet.
- Lever the keypad off. Just slide your plastic tool underneath the
keypad to release it.
- Now slide your plastic tool under the LCD screen. It should come
away with little force. Then lift the LCD up and over so it sits on top
of the front cover. Again, it is still attached by ribbons so it can't
be removed completely yet.
- With the LCD slipped over, your phone should now look like below.
Remove the two screws you can see and the battery compartment will come
loose.
-
Below you see the battery compartment removed. I have also flipped the
front cover and LCD back over to cause less stress on the ribbons whilst
performing the next action (and taking the photo). A ribbon connector is
circled below. It attaches like a plug and socket. Just lever it away
from the circuit board to disconnect it.
-
Note that the connector, circled at the bottom of the picture is the one
you disconnected in the stage above. Now lift the circuit board up to
access some more ribbon connectors. Again it attaches like a plug and
socket. Just lever it away from the circuit board to disconnect it.
-
The connector circled below, left, again attaches like a plug and
socket. Just lever it away from the circuit board to disconnect it. The
other connector is slightly different. The brown part at the top of the
connector is a latch. Pull this up, towards you then pull the circuit
board away from the rest of the phone and the ribbon will slide out.
- Your phone should now look like below. The front cover, screen and
main body of the phone will now be loose and can be separated.
-
Your phone should now look like below.
You can now replace the LCD screen. Reverse the whole procedure for reassembly.
If you have any questions about Nokia 5800 Xpress Music disassembly, email
rob.lee@formymobile.co.uk or contact us on Facebook for further help with
Nokia 5800 Xpress Music disassembly.
|
|
ABOUT
