If you require a replacement screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=2760lcd
Tools required for disassembly: Torx 6 screwdriver, plastic tool such as a guitar
plectrum or credit card.
- Remove your back cover, battery and sim. There are a
number of screws in the back of the phone but you don't need to remove
these in order to change the LCD screens, so ignore them
for now.
- Open the flip and you'll see two rubber stoppers, circled below,
which cover two screws. Push these off with your screwdriver or
something sharp and then remove the screws.
- Run something thin and flat, like the edge of a credit card, around
the join of the front cover in order to release it.
- With the front cover removed, your phone should look like below.
Three ribbon connectors, circled, need to be disconnected. Each of these
attaches like a plug and socket. Just lever each one up to unplug..
- With the three ribbons disconnected, your phone should look like
below. Four clips hold the circuit board in place, indicated by the
arrows. Gently pry these back and then lift the circuit board over the
guide pin, circled below in red.
- With the circuit board removed, your phone should look like below.
To remove the large LCD screen, which is indicated by the arrow below,
simply lift it away from the main body of the phone. It will be loose
and will come away with no force.
- With the large LCD screen removed your phone should look like below.
If you want to remove the earpiece (circled), simply lever it free.
-
Below you can see the earpiece once removed.
-
To remove the small LCD screen, slide your plastic tool all the way
under until it is released.
-
With the small LCD screen removed, your phone should now look like below.
If you only want to replace the LCD screen, you don't need to follow the
guide any further. Reverse the whole procedure for reassembly.
- To continue taking the phone apart, remove the four screws from the
back of the phone.
-
Starting near the top of the phone, lever the battery compartment free.
-
With the battery compartment removed, your phone should look like below.
Disconnect the circled ribbon. Again, it attaches like a plug and
socket. You can then lift the circuit board out.
-
With the circuit board removed, your phone should look like below.
Disassembly is now complete. Reverse the whole procedure for reassembly.
If you have any questions about Nokia 2760 disassembly, email
rob.lee@formymobile.co.uk. Or contact us on Facebook for further help with
Nokia 2760 disassembly.
If you require a replacement screen, phone cover and screwdrivers, they can be purchased
here:
http://www.formymobile.co.uk/proddetail.php?prod=2760lcd
|
